Bid guide
How to bid on strut arm ring springs for the U.S. Army Corps of Engineers
What the Army Corps is buying
The U.S. Army Corps of Engineers, St. Louis District, needs 12 new sets of strut arm ring springs and suitable surface and filler lubricants for Jerry F. Costello Lock and Dam. The materials are intended as in-kind replacements for existing equipment; installation will be done by others.
This is a supplies opportunity for vendors that can furnish the specified replacement materials.
Deadline and amendment
The RFP was published October 22, 2026, and proposals are due November 6, 2026, at 11:00 AM ET. The solicitation lists Amendment 0001 as posted October 22, 2026.
The deadline is the point by which your response must be submitted. Check the solicitation documents for the submission instructions and any details about the deadline.
Who this opportunity suits
This opportunity may suit suppliers that can provide strut arm ring springs and suitable surface and filler lubricants for an in-kind replacement. The listed category is supplies.
Because installation will be done by others, the stated requirement is to furnish materials rather than install them.
How to access the solicitation
Click “View original source” to open the opportunity on the portal. If the first click takes you to the portal homepage, click it again to go to the bid.
You may need a free account to view the documents, though some bids can be viewed without one. Review the Instructions to Offerors, Quote Schedule, and Statement of Work.
Prepare a clear, complete response
Use the Quote Schedule and Statement of Work to check what materials the agency is requesting and make sure your response addresses the full requirement, including the 12 sets and the lubricants.
Read the Instructions to Offerors carefully, and review Amendment 0001 alongside the solicitation documents. Allow time to complete and submit your response before the stated deadline.
See the live bid — deadline, agency details, and how to respond
Dates and requirements can change via addenda; always verify on the bid page and at the original source before responding.
View this bid on BiddingSimpleThis guide was prepared by BiddingSimple from the solicitation’s public posting. It is not official guidance from DEPT of the Army; the original posting controls.